Zoom the image with the mouse
Aitcool
Aitcool 2.5cfm Single Stage Pump
Product Code:
VP130N
Condition:
New
Availability:
Ready To Ship!
£94.99
The Aitcool brand makes exceptional products - all their pumps are CE marked, a European quality standard.
This single stage pump is relatively lightweight and efficiently pulls a vacuum on smaller chambers, such as the 5L or 8L, and for small open blast and closed loop systems.
The pump comes as standard with rubber feet to dampen vibrations/reduce noise and a carry handle. Additionally a power supply and UK plug are included. This pump does not come as standard with a filter.
Please start by reading the instruction manual included. First, fill the pump with the supplied oil - take care to not fill past the halfway mark.
We recommend a maximum of 15 minutes to run the pump in total. It should take no longer than 5 minutes to pull a full vacuum. Once you have done this, close the valve on the chamber and then turn off the pump. Remove the hose between the pump and chamber to stop pump oil being pulled into the chamber.
After this initial pull, the vacuum can be maintained for up to 100 hours or longer but the pump itself can never be run continuously.
The chamber may lose a little pressure over a period of time, so simply turn on your pump and then open the valve on your chamber to pull a full vac again.
Capacity Information:
- 1/4 HP motor.
- Pump speed: 1440 rpm.
- 180ml oil capacity.
- 220v/50hz voltage.
- Weight: 4.3kg approx.
- 240 x 93 x 200mm.
- Partial pressure: 2Pa.
- Total pressure: 150 microns.
- ¼” SAE 7/16 JIC inlet port.
Aitcool 2.5cfm Single Stage Pump
£94.99
The Aitcool brand makes exceptional products - all their pumps are CE marked, a European quality standard.
This single stage pump is relatively lightweight and efficiently pulls a vacuum on smaller chambers, such as the 5L or 8L, and for small open blast and closed loop systems.
The pump comes as standard with rubber feet to dampen vibrations/reduce noise and a carry handle. Additionally a power supply and UK plug are included. This pump does not come as standard with a filter.
Please start by reading the instruction manual included. First, fill the pump with the supplied oil - take care to not fill past the halfway mark.
We recommend a maximum of 15 minutes to run the pump in total. It should take no longer than 5 minutes to pull a full vacuum. Once you have done this, close the valve on the chamber and then turn off the pump. Remove the hose between the pump and chamber to stop pump oil being pulled into the chamber.
After this initial pull, the vacuum can be maintained for up to 100 hours or longer but the pump itself can never be run continuously.
The chamber may lose a little pressure over a period of time, so simply turn on your pump and then open the valve on your chamber to pull a full vac again.
Capacity Information:
- 1/4 HP motor.
- Pump speed: 1440 rpm.
- 180ml oil capacity.
- 220v/50hz voltage.
- Weight: 4.3kg approx.
- 240 x 93 x 200mm.
- Partial pressure: 2Pa.
- Total pressure: 150 microns.
- ¼” SAE 7/16 JIC inlet port.
Related Products
